I have just set up the fop2, and like it. I am having an issue where I don't see the status of trunks.
It is configured properly, I believe. Where would any error logs be?
Thx
I have just set up the fop2, and like it. I am having an issue where I don't see the status of trunks.
It is configured properly, I believe. Where would any error logs be?
Thx
Do you see trunk buttons at all? If you do not see them, maybe you hit the 15 button limit on the free version.
Best regards,
--
Nicolás
Hello,
Yes I see the buttons, and I only have 10 total buttons configured. The trunk buttons just do not show any calling information? The extension buttons work. I have yet to check the conference or que buttons.
Do you see trunk buttons at all? If you do not see them, maybe you hit the 15 button limit on the free version.
Best regards,
--
Nicolás
Can you post your trunk button definition? What kind of channel are you monitoring?
The trunks are all SIP...
-------------------------
SIP/2000]
type=extension
extension=2000
context=from-internal
label=Seemore Phone1
mailbox=2000@default
extenvoicemail=*2000@from-internal
[SIP/2500]
type=extension
extension=2500
context=from-internal
label=Seemore Phone2
mailbox=2500@default
extenvoicemail=*2500@from-internal
[SIP/2501]
type=extension
extension=2501
context=from-internal
label=Seemore Phone3
mailbox=2501@default
extenvoicemail=*2501@from-internal
[SIP/2006]
type=extension
extension=2006
context=from-internal
label=Seemore Phone4
mailbox=2006@default
extenvoicemail=*2006@from-internal
[QUEUE/9000]
type=queue
label=Telemarketer
extension=9000
context=from-internal
[ViaTalk]
type=trunk
label=ViaTalk
[VoipDiscount]
type=trunk
label=VoipDiscount
[FreeDigits]
type=trunk
label=FreeDigits
[CONFERENCE/100]
type=conference
label=Conference 100
extension=100
context=from-internal
Hi,
Your trunk definition is not correct, you should use their channel technology, like:
[SIP/ViaTalk]
Best regards,
OK..
Just tried this again and it did work. Great, thanks. I could have sworn I had tried that before though....
Does that status only show how many calls are on a trunk, or does it also show the incoming call information?
Thx
Great it worked... trunk buttons only show the number of channels being used, with no extra information.
In my case I am using PRI trunks and have already changed DAHDI to ZAP in autoconfig-buttons-freepbx.sh. All I am getting for trunk use on the panel is "1 lines in use" even when I have 10 active inbound or outbound calls. How do I get the panel to show 23 PRI channels ?
Hi Ronald,
You can run the autoconfig-buttons-freepbx.sh config script in the linux console and check its output. A Trunk button should list every channel on the pri with "Channel=" directives, something like:
[ZAP/1]
type=trunk
label=My Pri
channel=ZAP/2
channel=ZAP/3
..
If your modification was done in half, you might get something like:
[ZAP/1]
type=trunk
label=My Pri
channel=DAHDI/2
And that will fail to monitor ZAP/2.
I am just guessing, but that might be the issue you are having.
Best regards,
--
Nicolás